1. If the semi-finished products are wrinkled during winding, the pressure of the tension cylinder can be appropriately increased.

2. Whether the tension of the coiling shaft is too tight or closely related to the glue during gluing when the finished products are uncoiled.

3. When the semi-finished product is loose in the middle, it is closely related to uneven gluing and uneven base material. At this time, the bow roll should be adjusted to support it, or the tension of the winding shaft should be increased, and the base material should be compacted with a knife tube.

4. Induction switch function and adjustment:

① The induction switches of this machine are fixed-point type, without any adjustment.

② Counter induction: four-point induction, matching with three-section length. Counter, smooth braking and precise control.

③ Exchange axis induction: the counter is accumulated once for each axis change to calculate the quantity of finished products.

5. Winding shaft tension setting:

① The tension of the tape on the coiling shaft is controlled by the tension adjusting nut.

② Turn the nut clockwise to tighten the adhesive tape. Turn the nut counterclockwise to loosen the adhesive tape.

6. Handling of non-parallel winding shaft:

① Check whether the left and right sprockets are loose.

② Install the four take-up shafts, make horizontal adjustment on both sides, correct the position, and rely on the adjustment screws on both sides of the inner sprocket on the right side for adjustment. First adjust the left side to the required angle, and then adjust the right side to the horizontal.

7. Scrap coiling and adjustment:

① Properly adjust the bushing on the blank shaft to align it with the position of the blank.

② First operate manually until enough leftovers can entangle the leftover take-up shaft.

③ When the machine starts the slitting operation, the leftovers will be automatically rolled.